FAQ
From the given table, depending upon the required power transmission, abelt section is chosen. However, the smaller pulley diameter should be lessthan the pulley diameter as mentioned for the chosen belt section.
Let a V-belt of section A hasinside length of 3012 mm. Then its designationwill be A 3012/118. Where, 118 is the corresponding length in inches.
Yes, provided you follow the MATCHED SET principle. Email ICP for any assistance in this regard.
MATCHEDSETS: The question of matched sets arises incase of multi V belt drive as the length of V belt should be matched in order to obtain even distribution of load.A ‘Matched Set’ is simply a set of such belts, the length of which are within the specified limits, so that these can be used together.
References
- [1]. Shigley, J. E. (2011). Shigley’s mechanical engineering design. Tata McGraw-Hill Education
- [2]. Spotts, M. F. (1953). Design of machine elements. NiraliPrakashan.
- [3]. Khurmi, P. S., and J. K. Gupta. “A textbook of machine design, first multicolour edition.” Eurasia Publishing House Ltd 7361 (2005): 509-556.
- [4]. Sharma, C. S., &Purohit, K. (2003). Design of machine elements. Prentice-Hall of India.
- [5]. Maleev, V. L., & Hartman, J. B. (1939). Machine design. International Textbook Co.
- [6]. JKFenner India, Product Guide
Disclaimer: Information’s, written and verbal are provided by ICP, relative to its products which it determines to bereliable & no liabilities of whatsoever nature in regards to its uses. The purchaser of FENNER/Gates/MEGADYNE/Continental/other brand industrialproducts should determine for itself the suitability of such products.
